Watch How To Pack the Series 3
What You’ll Need
- Series 3 Sportube Hard Case
- Two rubber brake retainers (included)
- Wire Case Pin (included) or TSA-approved lock (not included)
Step-by-Step Packing Instructions
- Prepare Your Skis and Poles
- Separate skis and lay bases on the floor.
- Push down on the brake, lifting up the brake arms, use the rubber brake retainers to secure the brakes in the retracted position. The band goes over the top of the binding, not around the ski edge.
- Repeat for the other ski.
- Separate the Hard Case
- Remove the included Wire Case Pin to split the Hard Case into top and bottom halves.
- Prepare Your Snowboard
- Place the snowboard on a flat surface.
- Lay boots on tip or tail of the snowboard.
- Place Skis
- Place skis bases out on top of the snowboard and boots. You may need to stagger the skis depending on the alignment of the bindings.
- You can add any additional gear like jackets, pants, gloves, etc.
- Slide in the poles where they fit best.
- Lock the Case
- Insert the included Wire Case Pin or TSA-approved lock through one of the two holes on the case to secure it. Note: the two holes in the outer section of the case are NOT designed to line up concurrently with any two holes on the inner (wheeled) case. Cinching the top of the case down on the tip of the skis minimizes movement of skis within the case.
Packing Tips
- Ensure the case is packed snugly to prevent any movement during transit.
- Always remove the Easy Pull Handle at the top of the Hard Case when checking, shipping or driving your case.
