What You’ll Need
- Series 1 Hard Case
- Two rubber brake retainers (included)
- Wire Case Pin (included) or TSA lock (not-included)
Step-by-Step Packing Instructions
- Prepare Your Skis and Poles
- Separate your skis and lay the bases on the floor.
- Push down on the brake, lifting up the brake arms, use the rubber brake retainers to secure the brakes in the retracted position. The band goes over the top of the binding, not around the ski edge.
- Repeat for the other ski.
- Align your skis tip to tail with the bindings inwards and the bases facing outwards, like shoes in a box
- Insert Skis into the Wheeled Section
- Separate the Hard Case in two by removing the included Wire Case Pin.
- Slide your skis and poles into the lower half of the Hard Case.
- Close the Case
- Slide the top half of the Hard Case over the bottom half that has your skis and poles inside.
- Slide until the top half reaches the top of your skis for the most secure fit.
- Lock the Case
- Insert the included Wire Case Pin or TSA-approved lock through one of the two holes on the case to secure it. Note: the two holes in the outer section of the case are NOT designed to line up concurrently with any two holes on the inner (wheeled) case. Cinching the top of the case down on the tip of the skis minimizes movement of skis within the case.
Packing Tips
- Ensure the case is packed snugly to prevent any movement during transit.
- Always remove the Easy Pull Handle at the top of the Hard Case when checking, shipping or driving your case.
