How to Pack the Series 2 with Skis

What You’ll Need

• Series 2 Hard Case
• Two rubber brake retainers (included)
• Four ski straps (included)
• Wire Case Pin (included) or TSA-approved lock (not included)

Step-by-Step Packing Instructions

1. Prepare Your Skis and Poles
   • Separate skis and lay bases on the floor.
   • Push down on the brake, lifting up the brake arms, use the rubber brake retainers to secure the brakes in the retracted position.  The band goes over the top of the binding, not around the ski edge.
   • Repeat for all skis.
   • Align skis tip-to-tail with bindings facing inward and bases outward. like shoes in a box
   • Wrap the hook & loop ski straps (included) around tip and tail of skis.
2. Separate the Hard Case
   • Remove the included Wire Case Pin to split the Hard Case into top and bottom halves.
3. Insert Skis into the Bottom Half
   • Slide skis and poles carefully into the bottom half of the case and attach the case mounted hook & loop straps around the skis
   • Repeat with second pair of skis and poles.
   • Ensure skis sit securely and are aligned straight within the case.
   • Use the hook & loop straps attached the to the bottom half of the case to further secure skis and poles from movement.
4. Close the Case
   • Slide the top half of the Hard Case over the bottom half containing your skis and poles.
   • Slide until the top half reaches the top of your skis for the most secure fit.
5. Lock the Case
   • Insert the included Wire Case Pin or TSA-approved lock through one of the two holes on the case to secure it.  Note: the two holes in the outer section of the case are NOT designed to line up concurrently with any two holes on the inner (wheeled) case.  Cinching the top of the case down on the tip of the skis minimizes movement of skis within the case.

Packing Tips

• Pack snugly to prevent movement during transit.
• Always remove the Easy Pull Handle when checking, shipping, or mounting the case on a vehicle roof rack.